This series is outdated. I wrote a book about regular script, which I recommend over reading this.
This post is meant to provide a clear-cut standard for beginners regarding Chinese handwriting using common hard-tipped writing instruments like pencils and pens, focusing on regular script (楷書). This is necessary because commonly available materials provide inaccurate information or stray too far into aesthetics too early, while neglecting the basics. My goal here is not to get you to write well, but to write correctly. The examples I show are made with a pencil, only caring to ensure that things are correct where they should be, with no attention paid to aesthetics.
First, some axioms.
- Writing is a form of communication through symbols. Recognition of these symbols without distraction requires them to adhere to certain rules. These rules are called 書法, “writing rules.”
- Characters in regular script are recognized based on the length, direction, and placement of strokes. Stroke thickness is not essential. Therefore, regular script can be written correctly with a monoline writing instrument. However, an atypical scheme of line thickness variation that becomes distracting is still wrong.
With that, your goal when writing (regardless of writing instrument) should be to communicate without distraction. The most common potential distraction when writing is producing wrong characters. In general, writing something that has not been commonly employed in exemplary pieces of writing for that particular morpheme will probably result in a wrong character. More concretely, the difference between a right and wrong character can depend on:
- Substitution of one character for another, e.g. instead of
- Substitution of one component for another, e.g. for .
- Absence of a required stroke (which may result in a substitution), e.g. for .
- An extra stroke, e.g. for .
- Stroke placement is incorrect, e.g. for .
- Substitution of one type of stroke for another, e.g. for.
- Width relationship of certain strokes are incorrect, e.g. for .
- Height relationship of certain strokes are incorrect, e.g. for .
- Width relationship of certain components are incorrect, e.g. for .
- An opening where there should be none, e.g. for .
- Lack of an opening where there should be one, e.g. for .
- Visibly incorrect stroke order, e.g. for
I think that about covers it. The first piece of homework you have to do, then, is to learn to recognize and reproduce the basic strokes of regular script. They are most reliably recognized by their orientation and curvature. The number of different strokes varies depending on how you count. I only include those which I think differ significantly in technique.
A horizontal stroke, commonly called 橫, is written from left to right. It can be truly horizontal or tilted up at the right a bit. It rare cases it can be tilted down, but not doing so in such a case will not make the difference between a right and wrong character. It may bow up (most commonly) or down in the middle, but not extremely. If you vary the thickness, it must be thick on both ends.
A vertical stroke, commonly called 豎, is written from top to bottom. It must not curve. In most cases it should be ideally truly vertical. In some cases such as in the second stroke of 五 it can slant and still be a vertical stroke as long as it does not curve. When written with line width variation, both ends are usually thick, although in some cases it can end in a point, and sometimes it must end in a point.
A positive-sloped stroke, commonly called 撇, is written from the upper right to the lower left. Lengths and curvatures of these strokes vary greatly. It usually bows down in the middle. In rare cases it must either be completely straight or bow up, such as the second stroke of 為 (examples). If you vary thickness, in most cases it must start thick and end thin. In some cases, such as in the third stroke of 鹿, it may start with a point, however not doing so will not result in a wrong character.
Dots, commonly called 點, are short strokes going in some downward direction, written from the top. When writing with varying line thickness, start with a point and increase thickness until the end.
The dot to the right can be lengthened using the same technique, resulting in a straight or upwards-bowing negative slope stroke, called 長點 or 反捺.
A negative slope stroke that bows down in the middle is called 捺. At the top, if it is closer to horizontal, there is initially a rightward motion. If it is steeper, it starts directly in the downward bow. If it starts in the middle of another stroke, it starts with a point. If not, it likely must start thick, as in the last stroke of 之 (examples).
A stroke that is written from the bottom left to the upper right, and tilts up more than a horizontal stroke, is called 提. These are never the last stroke of a character. They start thick and end thin.
A round curve of about 90 degrees is called 彎. They are usually a transition between a vertical and horizontal stroke.
Hooks, called 鉤, are short attachments to major strokes. Most of them are very straightforward. On horizontal strokes, hooks can only go down. On vertical strokes, hooks can only go left.
One stroke only occurs with a hook. I don't know what it's called, but it occurs in the last stroke of 子 and the second stroke of 狗. It is rather vertical but bows to the right, starting thin and ending thick (where the hook starts, which ends thin again).
Hooks attached to rather steep 捺 are likely called 斜鉤. However, there are steep 捺 where you must not hook, as in the 4th to last stroke of 國 (example). The hook should point straight up or slightly to the right, even if the next stroke occurs left of it, except in 心 and 必, where it should point left.
Corners are the end of one stroke and the beginning of another. Corners can be correctly made by lifting your writing instrument up and starting a stroke that covers the end of the previous stroke. However, if at the end of one stroke you feel that you are prepared to start another, then go ahead and connect them. Note that stroke counts for dictionary classification are made assuming cornered strokes are connected into one where possible. Therefore, while I would write 幺 in 5 separate strokes, a dictionary would say it has 3 strokes.
(Continued in Part 2)